STARTING/CHARGING – Buick Park Avenue Ultra 2000 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Buick Park Avenue Ultra 2000

List of elements for Charging Wiring Diagram for Buick Park Avenue Ultra 2000:

• (not used)
• B11
• B12
• Battery
• Body control module (sdm) (behind glove box)
• D12
• G112 (lower left side of engine)
• Gen. terminal f monitor
• Gen. terminal l control
• Generator
• I/p fuse block (behind glove box)
• Instrument cluster
• Powertrain control module (pcm) (on left front of engine compartment, in air cleaner housing)
• Red
• Serial data class 2
• Starter motor
• Underhood fuse block (on right front of engine compartment, near battery)
• Volt indicator

Starting Wiring Diagram for Buick Park Avenue Ultra 2000

List of elements for Starting Wiring Diagram for Buick Park Avenue Ultra 2000:

• (2000)
• (2001)
• Accy
• Battery
• Body control module (sdm) (behind glove box)
• Computer data lines system
• Crank positive voltage
• Crk fuse 5a
• D10
• D12
• D14
• F10
• F11
• G112 (lower left side of engine)
• Hold in coil
• Hot in run & start
• I/p fuse block (behind glove box)
• Ign crank sense
• Ignition switch
• Lock
• Nca
• Note: refer to power distribution system: ign relay
• Off
• Pcm fuse 10a
• Powertrain control module (pcm) (on left front of engine compartment, in air cleaner housing)
• Pull in coil
• Rear fuse block (below right side of rear seat)
• Red
• Run
• Run/crk fuse 15a
• Serial data class 2
• Start
• Starter ctrl
• Starter fuse 30a
• Starter motor
• Starter relay
• Starter solenoid
• Starting/charging system (charging circuit)
• Underhood fuse block (on right front of engine compartment, near battery)