STARTING/CHARGING – Chevrolet Corvette 2004 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Chevrolet Corvette 2004

List of elements for Charging Wiring Diagram for Chevrolet Corvette 2004:

• (behind right front fender, between wheelhouse & dash panel) powertrain control module (pcm)
• (below steering column) data link
• (near left side of bcm) star connector 1
• (not used)
• A11
• A13
• B6 pnk
• Battery
• Connector
• Fusible link (10 ga- rust)
• G104 (on right frame rail, below battery tray)
• G106 (on right side of engine, above starter)
• Generator
• Generator f terminal
• Generator l terminal
• Hot in on & start
• I/p fuse block (in right front footwell, mounted to toe board)
• Ignition
• Instrument panel cluster
• Ipc fuse 10a
• Logic
• Power distribution system
• Red
• Serial data
• Starter
• Volt- meter

Starting Wiring Diagram for Chevrolet Corvette 2004

List of elements for Starting Wiring Diagram for Chevrolet Corvette 2004:

• A red
• A/t
• A10
• Acc
• Battery
• Body control module (bcm) (mounted on toe board, in right footwell)
• Bulb test
• Clutch pedal start switch (on bracket in front of brake pedal)
• Crk fuse 10a
• F10
• Fusible link (10 ga- rust)
• G c1
• G104 (on right frame rail, below battery tray)
• G106 (on right side of engine, above starter)
• Generator
• Hot at all times
• I/p fuse block (in right front footwell, mounted to toe board)
• Ign 2 fuse 60a
• Ignition switch
• Lock
• M/t
• Off
• Park/neutral position (pnp) switch (on left side of transmission)
• Red
• Relay control
• Start
• Starter
• Starter fuse 60a
• Starter motor
• Theft deterrent relay (in right footwell, above bcm)
• Underhood fuse block (on right side of engine compartment)
• Underhood fuse block (on right side of engine compt)