STARTING/CHARGING – Pontiac Grand Am SE 1998 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Pontiac Grand Am SE 1998

List of elements for Charging Wiring Diagram for Pontiac Grand Am SE 1998:

• (1997) 3.1l 2.4l
• (1998) 3.1l
• (2.4l)
• (3.1l only)
• (3.1l)
• (buick/olds)
• (center dash, near tie bar)
• (front of engine)
• (left inner fender)
• (left side of dash)
• (not used) p
• (pont)
• B (2.4l) (3.1l)
• Battery
• C f
• C10
• C11
• C14
• Charge indicator
• Chg. ind. cont.
• Data link connector
• Engine compartment fuse center
• Fuse block
• G100
• G125
• Generator
• Generator terminal f input
• Generator terminal l outout
• Hot at all times
• Hot in off, run, bulb test or start
• Hvac blo mot fuse 30a
• Ign
• Inst fuse 10a
• Instrument panel cluster
• Microprocessor
• P b +
• Pnk
• Power distribution system
• Powertrain control module (pcm) (behind right side of dash)
• Prndl fuse 10a
• Red
• S s
• S277
• S391
• Serial data (uart)
• Starter solenoid
• Tan

Starting Wiring Diagram for Pontiac Grand Am SE 1998

List of elements for Starting Wiring Diagram for Pontiac Grand Am SE 1998:

• A/t
• Accy
• Battery
• Bulb test
• Charging circuit
• Clutch pedal position switch (lower left side of of dash, near steering column)
• Engine compartment fuse center
• G100 (left inner fender)
• G125 (front of engine)
• Hold- in coil
• Hot at all times
• Ign sw fuse 60a
• Ignition switch
• Lock
• M/t
• Off
• Power distribution system
• Pull- in coil
• Red
• Red b
• Red c
• Run
• S202
• Start
• Starter motor
• Starter solenoid
• Transaxle range switch (on left side of engine compt.)