SUPPLEMENTAL RESTRAINTS – Buick LeSabre Custom 2005 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraints Wiring Diagram for Buick LeSabre Custom 2005

List of elements for Supplemental Restraints Wiring Diagram for Buick LeSabre Custom 2005:

• A10
• A11
• A12
• A13
• A14
• A15
• A16
• A17
• A18
• Air bag indicator
• Case ground
• Class 2 serial data
• Computer data lines system
• Dash integration module (dim) (behind right side of dash, under sound insulator)
• Data link connector (dlc) (under lower left side of dash)
• G303 (under right front seat)
• Ground
• High control
• Hot in on or start
• Ignition
• Inflatable restraint front end sensor (front of engine compt)
• Inflatable restraint i/p module (right side of dash)
• Inflatable restraint sensing & diagnostic module (sdm) (under rear of center console, mounted to floor pan)
• Inflatable restraint steering wheel module (top of steering wheel)
• Inflatable restraint steering wheel module coil (steering wheel)
• Instrument panel cluster
• Left front inflatable restraint side impact module (left side of driver seat back)
• Left inflatable restraint side impact sensor (sis) (at base of left "b" pillar, behind trim panel)
• Logic
• Low control
• Nca
• Pnk
• Rear fuse block (under left rear seat)
• Right front inflatable restraint side impact module (right side of front passenger seat back)
• Right inflatable restraint side impact sensor (sis) (at base of right "b" pillar, behind trim panel)
• S202 (in i/p harness, 24cm from ipm breakout)
• Seat belt sw input
• Seat belt sw return
• Seat belt switch (closed w/ seat belt unbuckled) (in seat belt assembly, near floor)
• Sensor signal
• Sensor voltage
• Shorting bar
• Signal
• Sir fuse 8 15a
• Solid state
• Tan
• Voltage