SUPPLEMENTAL RESTRAINTS – Chevrolet Beretta Z26 1994 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraint Wiring Diagram for Chevrolet Beretta Z26 1994

List of elements for Supplemental Restraint Wiring Diagram for Chevrolet Beretta Z26 1994:

• 2.49 k
• 5.1 k
• 8.45 k
• A10
• A11
• A12
• Air bag fuse 3a
• Air bag ind
• Arming sensor (upper right side of i/p, attached to underside of upper dash panel)
• B10
• B11
• B12
• Convenience center (left side of i/p, above fuse block)
• Crank input
• Data link conn (dlc) (left side of i/p)
• Diagnostic energy reserve module (derm) (behind right front kick panel)
• Driver 36v loop rsrv
• Driver seat belt
• Driver side "high"
• Driver side "low"
• Driver source sense
• Engine controls
• Forward discriminating sensor (attached to radiator support)
• Fuse 10a
• Fuse 20a
• Fuse block
• G114 (vin a) (left rear of engine, above starter)
• G130 (vin 4 & vin m) (left rear of engine, on transaxle stud)
• G300 (under left front seat)
• Ground
• Hot in run, bulb test or start
• Hot in start
• Ign 1
• In-line fuse (upper left side of i/p, taped to i/p harness)
• Initiator module (under center of steering wheel)
• Instrument cluster
• Left front seat belt input
• Multi- function alarm module
• Nca
• Passenger compartment discriminating sensor (under center console)
• Pnk
• Redundant ind ground
• Redundant ind ign 1
• Seat belt sw
• Serial data line
• Shorting bar
• Sir coil assembly (top of steering column)
• Sir indicator ctrl
• Tan