SUPPLEMENTAL RESTRAINTS – Chevrolet Impala LS 2004 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraints Wiring Diagram for Chevrolet Impala LS 2004

List of elements for Supplemental Restraints Wiring Diagram for Chevrolet Impala LS 2004:

• (below driver door opening, rear of left "a" pillar) g301
• A10
• A11
• A12
• A13
• A14
• A15
• A16
• A17
• A18
• Air bag indicator
• C1 a1
• C217 a1
• Class 2 serial data
• Data link connector (dlc) (partial) (below left side of dash, right of steering column)
• F10
• G301 (below driver door opening, rear of left "a" pillar)
• Ground
• High control
• Hot in on & start
• If equipped
• Ignition
• Inflatable restraint front end discriminating sensor
• Inflatable restraint i/p module
• Inflatable restraint sensing & diagnostic module (below passenger's seat)
• Inflatable restraint steering wheel module
• Inflatable restraint steering wheel module coil
• Instrument panel cluster
• Left front inflatable restraint side impact module
• Left i/p junction block (left side of dash, behind access panel)
• Left inflatable restraint side impact sensor (impala: on left "b" pillar) (monte carlo: in driver's door)
• Left seat belt switch
• Left signal
• Logic
• Low control
• Nca
• Pnk
• Right i/p junction block (right side of dash, behind access panel)
• Sensor signal
• Shorting bar
• Signal
• Solid state
• Splice pack sp205 (in i/p harness, to right of park brake lever, taped over completely, between two strips of white tape)
• Srs fuse 10a
• Stage 1
• Stage 2
• Tan
• Voltage