SUPPLEMENTAL RESTRAINTS – Oldsmobile Cutlass Cruiser S 1994 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraint Wiring Diagram for Oldsmobile Cutlass Cruiser S 1994

List of elements for Supplemental Restraint Wiring Diagram for Oldsmobile Cutlass Cruiser S 1994:

• (behind center of i/p, below right side of ashtray) (buick)
• (buick)
• (olds)
• 2.49 k
• 5.1 k
• 8.45 k
• A10
• A11
• A12
• Air bag fuse 10a
• Air bag ind
• Anti-lock brakes
• Arming sensor (left of pcm)
• B10
• B11
• B12
• C1 c1
• C14 c15
• Convenience center (behind left side of i/p, near shroud)
• Crank input
• Data link conn (dlc) (below left side of i/p, near steering column)
• Diag request input
• Diagnostic energy reserve module (derm) (behind hvac control head)
• Driver 36v loop rsrv
• Driver seat belt
• Driver side "high"
• Driver side "low"
• Driver source sense
• Forward discriminating sensor (forward of condensor, below hood latch)
• G202 (near park brake bracket)
• G206 (behind i/p, on right side of steering column support) (olds)
• G402 (near left rear wheelhouse)
• Ground
• Guages fuse 10a
• Hot in run, bulb test or start
• Hot in start
• I/p fuse block
• Ign 1
• In-line fuse (right front corner of i/p, near fuse block)
• Inflator module (inside steering wheel hub)
• Instrument cluster
• Multi- function alarm module
• Nca
• Passenger compartment discriminating sensor (below center heater duct, under carpet)
• Pnk
• Redundant ground
• Redundant ind ign 1
• Safety belt input
• Seat belt sw
• Serial data line
• Shorting bar
• Sir coil assembly (inside steering wheel hub)
• Sir crank fuse 15a
• Sir indicator
• Tan