SUPPLEMENTAL RESTRAINTS
Supplemental Restraints Wiring Diagram for Pontiac Aztek Rally 2005
List of elements for Supplemental Restraints Wiring Diagram for Pontiac Aztek Rally 2005:
- (on right "b" pillar, under seat belt anchor) g302
- A10
- A11
- A12
- A13
- A14
- A15
- A16
- A17
- A18
- Air bag indicator
- Center console fuse block (in floor console)
- Class 2 serial data
- Computer data lines system
- Data link connector (dlc) (partial) (below steering column)
- Driver seat belt switch (in right half of driver seat belt)
- G301 (on left "b" pillar, under seat belt anchor)
- Ground
- High control
- Hot in run or start
- Ign
- Ignition
- Inflatable restraint i/p module (right side of dash, above glove box)
- Inflatable restraint sensing & diagnostic module (under right front seat)
- Inflatable restraint steering wheel module (in steering wheel)
- Inflatable restraint steering wheel module coil
- Instrument panel cluster (ipc)
- Left inflatable restraint side impact module
- Left inflatable restraint side impact sensor (at base of left "b" pillar, above seat belt retractor)
- Left seat belt switch
- Logic
- Low control
- Nca
- Right inflatable restraint side impact module
- Right inflatable restraint side impact sensor (at base of right "b" pillar, above seat belt retractor)
- S350 (driver seat harness, under driver seat, 13 cm from c313 breakout)
- Serial data class 2
- Shorting bar
- Signal
- Sir fuse 22 10a
- Splice pack sp205 (behind left side of dash access panel)
- Tan
- Voltage