TRANSMISSION – Chrysler Crossfire Limited 2008 – SYSTEM WIRING DIAGRAMS

TRANSMISSION

A/T Wiring Diagram for Chrysler Crossfire Limited 2008

List of elements for A/T Wiring Diagram for Chrysler Crossfire Limited 2008:

• (at rear of engine compt)
• (under left side of dash) data link connector
• 1-2/4-5 sol ctrl
• 2-3 sol ctrl
• 3-4 sol ctrl
• Brake lamp switch (at top of brake pedal)
• Btsi feed
• Can b bus (+)
• Can b bus (-)
• Computer data lines system
• Controller antilock brake (at left rear of eng compt)
• Exterior lights system
• Fuse 15a
• Fuse 5a
• Fused ill feed
• G203 (under center console)
• G204 (at right kick panel)
• Gnd
• Ground
• Hot at all times
• Hot in acc run or start
• Hot in run or start
• Ignition
• Interior lights system
• Mod press sol ctrl
• N2 & n3 speed sensors
• N2 input sp sens
• N3 input sp sens
• Pnk/red
• Power top control module (convertible) (at rear of trunk)
• Red
• Relay control module (in control module box)
• S122 (at rear of engine compt)
• S123
• S124 (at rear of engine compt)
• S125
• Sci transmit
• Sensor gnd
• Shift lever assembly
• Shift press sol ctrl
• Splice block (at left side of engine compt)
• Switch open in park and neutral
• Tcc sol ctrl
• Temp sensor p/n sw
• Traction rly ctrl
• Traction sys rly out
• Traction system relay
• Transmission control module (behind passenger footwell)
• Transmission solenoid assembly (at bottom of transmission)
• Transmission temperature sensor
• Underhood accessory fuse block (at left rear of engine compt)