TRANSMISSION
Transmission Wiring Diagram for Ford Crown Victoria Police Interceptor 2011
List of elements for Transmission Wiring Diagram for Ford Crown Victoria Police Interceptor 2011:
- (dash panel to headlight junction harness, near breakout to battery junction box (bjb))
- (engine control sensor & fuel charge wiring harness, near breakout to pcm)
- (left side of transmission) digital transmission range (dtr) sensor
- 4r70e transmission
- Battery junction box (bjb) (right front of engine compt, behind battery)
- C175b
- C175e
- C175t
- C192
- C260
- C261
- Case gnd
- Central junction box (cjb) (left of steering column)
- Computer data lines system
- Electronic throttle control (etc) motor (right rear of engine)
- Engine controls system
- Epc
- Etcref
- Etcrtn
- Feps
- Fuel pump relay
- Fuse 10a
- Fuse 15a
- Fuse 30a
- G106 (left rear of engine compt)
- G107 (left rear of engine compt)
- G109 (front of right fender)
- Hot at all times
- Hot in run or start
- Iat
- Ignition coils relay
- Maf
- Mafrtn
- Mass air flow/intake air temperature (maf/iat) sensor (behind air cleaner assembly)
- Oss
- Output shaft speed (oss) sensor (left side of transmission)
- Pcm power diode
- Pcm power relay
- Power distribution system
- Powertrain control module (pcm) (left rear of engine compt)
- Pwr gnd
- Red
- S118
- S119
- S121
- S146
- S147
- S276
- Sigrtn1
- Ssa
- Ssb
- Tacm+
- Tacm-
- Tcc
- Tcs
- Tft
- Throttle position sensor (on throttle body)
- Tp1-ns
- Tp2-ps
- Tr1
- Tr2
- Tr3a
- Tr4
- Transmission control switch (steering column)
- Tss
- Turbine shaft speed sensor (left side of transmission)
- Vpwr