TRANSMISSION – Infiniti M35h 2012 – SYSTEM WIRING DIAGRAMS

TRANSMISSION

Transmission Wiring Diagram for Infiniti M35h 2012

List of elements for Transmission Wiring Diagram for Infiniti M35h 2012:

• (left side of dash) m11
• (right end of dash)
• 12c
• A/c auto amp
• A/t assembly
• A/t fluid temp sensor
• A/t shift selector
• Anti- interlock solenoid valve
• Auto
• Batt
• Batt pwr sply
• Brake solenoid valve
• Can-h
• Can-l
• Canh
• Clutch 1 solenoid valve
• Combination meter
• Computer data lines system
• Direct clutch solenoid valve
• Drive mode select switch
• E106
• Eco
• Exterior lights system
• F103
• F58 (front of engine)
• Front brake solenoid valve
• Fuse & fusible link block (on battery positive post)
• Fuse 10a
• Fuse block (j/b) (behind left end of dash)
• Gnd
• High & low reverse clutch solenoid
• Hot at all times
• Hot in on or start
• Ignition sig
• Ill
• Input clutch solenoid valve
• Input speed sensor 1
• Input speed sensor 2
• Interior lights system
• Ipdm e/r (intelligent power distribution module engine room) (right rear of engine compt)
• Joint connector
• K-line
• Line pressure solenoid valve
• Low brake solenoid valve
• M116
• M135
• M201
• M26
• M30
• M95 (right side of dash)
• Manual
• Manual mode
• Mode select switch
• Mode sig
• Output speed sensor
• Pcb harness
• Pnk
• Position select switch
• Red
• Select sw (eco)
• Select sw (snow)
• Select sw (sport)
• Select sw (standard)
• Shift dwn sig
• Shift interlock system
• Shift lock unit
• Shift up sig
• Snow
• Sport
• Standard
• Starting/charging system
• Sw1
• Sw2
• Sw3
• Sw4
• Tan
• Tcm (transmission control module)
• Transmission range switch
• Transmission range switch assembly
• Valve
• Vign
• Vign rev lamp rly can-l start rly