TRANSMISSION
A/T Wiring Diagram for Nissan Maxima GLE 1999
List of elements for A/T Wiring Diagram for Nissan Maxima GLE 1999:
- (behind left side of dash) data link connector (for consult)
- (left rear side trnsaxle) park/neutral position switch
- 1-sw
- 13g
- 17j
- 18j
- 19j
- 2-sw
- A/t device (overdrive control switch) (below front console)
- A/t fluid temp sensor
- Acsd
- Acsd 4th
- All times
- Ascd control unit (behind dash, right of steering column)
- Automatic transaxle
- Avcc
- Brake sw
- Closed throttle
- Combination meter
- D-sw
- Dropping resistor (on left side of eng compt)
- Eccs control module (ecm) (below center of dash)
- Fld temp
- Full sw
- Fuse 10a
- Fuse 15a
- Fuse 4 7.5a
- Fuse 7.5a
- Fuse block (behind left side of dash)
- G134 (top of engine)
- G201 (right side of dash)
- Gnd
- Gnd-a
- Hot at
- Hot in on or start
- Idle
- Idle sw
- J/c 25 (behind center of dash)
- Lan
- Line press sol valve
- Lu duty
- Mem b/u
- N-sw
- Nca
- O/d ind
- O/d off ind
- O/d sw
- Over- run clutch sol
- Ovr/c
- Pl duty
- Pnk
- R-sw
- Red
- Revolution sensor (right rear of transaxle)
- Sen pwr
- Sens gnd
- Shift a
- Shift b
- Shift sol valve a
- Shift sol valve b
- Sss in
- Sss out
- Stoplight switch (on bracket, above brake pedal)
- Tacho
- Tcc sol valve
- Throttle position switch (on throttle body assembly)
- Transmission control module (tcm) (below center console, forward of shift lever)
- Ts in
- Tvo1
- Tvoo
- Unified meter control unit
- Vehicle speed sensor (on transaxle)
- Vign
- Vsp
- Vsp-1
- Vsp-2
- Wot