TRANSMISSION – Nissan Sentra S 2007 – SYSTEM WIRING DIAGRAMS

TRANSMISSION

A/T Wiring Diagram for Nissan Sentra S 2007

List of elements for A/T Wiring Diagram for Nissan Sentra S 2007:

• (front of engine)
• (left side of transaxle) park/neutral position switch
• A/t check
• Atf temp sens
• Batt
• Can-h
• Can-l
• Chip select (sel1)
• Clock (sel2)
• Combination meter
• Computer data lines system
• Cvt device (under front of center floor console)
• Cvt fluid temp sensor
• Cvt unit (left side of transaxle)
• D range sw
• Data i/o (sel1)
• E43
• Ecm (on left side of firewall)
• F9 (front of engine)
• Fuse 10a
• Fuse 20a
• Fuse block (j/b) (behind left end of dash)
• Gnd
• Hot at all times
• Hot in on or start
• Ign
• Ipdm e/r (intelligent power distribution module engine room) (left front of engine compt)
• K-line
• L range sw
• L/u&select- on/off sol
• L/u&select-liner sol
• Line pressure solenoid valve
• Lock-up select solenoid valve
• M61
• N range sw
• O/d control sw
• O/d off
• P range sw
• Pl liner sol
• Pnk
• Pri oil press sens
• Pri speed sens
• Primary pressure sensor
• Primary speed sensor (left side of transaxle)
• R range sw
• Red
• Rom assembly
• S/m-a
• S/m-b
• S/m-c
• S/m-d
• Sec liner sol
• Sec oil press sens
• Sec speed sens
• Secondary pressure sensor
• Secondary pressure solenoid valve
• Secondary speed sensor (top of transaxle)
• Sens power source
• Sensor gnd
• Starting/ charging system
• Step motor
• Tcm (transmission control module) (left front of engine compt)
• Torque converter clutch solenoid valve
• Unified meter control unit
• Vign