TRANSMISSION
3.3L
3.3L, A/T Wiring Diagram for Nissan Xterra XE 2000
List of elements for 3.3L, A/T Wiring Diagram for Nissan Xterra XE 2000:
- (on right side of transmission) park/neutral position switch
- 1-sw
- 11p
- 2-sw
- A/t device (overdrive control switch) (on steering column, below selector lever)
- A/t fluid temp ind
- A/t fluid temp sensor
- A/t fluid temperature switch
- Acsd 4th
- Ascd control unit (behind dash, left of steering column)
- Atck
- Automatic transaxle
- Avcc
- Behind lower cover)
- Closed throttle
- Combination meter
- Crui acsd
- D-sw
- Data in
- Data link connector (at left side of dash, behind fuse box cover)
- Data out
- Diode 2 (behind left side of dash)
- Dropping resistor (right front coner of engine compt, near battery)
- Dt1
- Dt2
- Dt3
- Eccs control module (ecm) (below center of dash,
- Eccs relay (below center of dash, near ecm)
- Fld temp
- Full sw
- Fuse 10a
- Fuse 7.5a
- Fuse block (left side of dash, behind cover)
- G119 (right front of engine)
- G200 (left kick panel)
- Gnd
- Gnd-a
- Hot at all times
- Hot in on or start
- Idle sw
- J/c 2 (behind center of dash)
- J/c 4 (behind center of dash)
- Line press sol valve
- Lu duty
- Mem b/u
- N-sw
- Nca
- O/d ind
- O/d off ind
- O/d sw
- Obd2
- Over- run clutch sol
- Ovr/c
- Pl duty
- Pnk
- R-sw
- Red
- Revolution sensor (on top rear of transmission)
- Sen pwr
- Sens gnd
- Shift a
- Shift b
- Shift sol valve a
- Shift sol valve b
- Ss of
- Tach
- Tacho
- Tcc sol valve
- Th sens
- Throttle position sensor & switch (on throttle body)
- Transmission control module (tcm) (behind dash, left of steering column)
- Tvo1
- Tvoo
- Unified meter control unit
- Vehicle speed sensor (right rear of transmission)
- Vign
- Vsp
- Vsp-1
- Vsp-2
- Wot