WARNING SYSTEMS – Buick Enclave CX 2008 – SYSTEM WIRING DIAGRAMS

WARNING SYSTEMS

Warning Systems Wiring Diagram for Buick Enclave CX 2008

List of elements for Warning Systems Wiring Diagram for Buick Enclave CX 2008:

• Air bag fuse 10a
• Auto
• Body control module (bcm) (under left side of dash)
• Brake fluid level signal
• Brake fluid level switch (on right side of brake fluid reservoir)
• Brake ind
• Buick w/ power windows
• Computer data lines system
• Driver door latch assembly (rear of driver's door)
• Driver door module (ddm) (buick w/ power windows) (in driver's door arm rest)
• Driver seat belt switch (in driver's seat belt buckle)
• G301 (behind left kick panel)
• G303 (near base of left "b" pillar)
• Gmc/saturn w/ power windows
• Head
• Headlamp switch
• Hot at all times
• Hot w/ ign relay energized
• I/p fuse block (behind right end of dash)
• Ign ii/iii/key in ign
• Ignition switch
• Inflatable restraint passenger air bag on/off indicator
• Inflatable restraint sensing & diagnostic module (sdm) (under floor console)
• Instrument panel cluster (ipc)
• J215
• J251
• J555
• Key in ignition switch
• Left seat belt sw sig
• Lf door ajar sw sig
• Logic
• Low ref
• Low spd gmlan ser data
• Low speed gmlan serial data
• Low tire pressure ind
• Off
• Park
• Park brake sw sig
• Park brake switch (on park brake assembly)
• Passenger seat belt ind
• Passenger seat belt switch (in front passenger's seat belt buckle)
• Pnk
• Pwr mode fuse 2a
• Radio
• Rear prk lps sply volt
• Right seat belt sw sig
• Seat belt ind
• Underhood fuse block (above right front wheelwell)