WARNING SYSTEMS – Chevrolet Corvette 2003 – SYSTEM WIRING DIAGRAMS

WARNING SYSTEMS

Warning Systems Wiring Diagram for Chevrolet Corvette 2003

List of elements for Warning Systems Wiring Diagram for Chevrolet Corvette 2003:

• A11
• A13
• A15
• A16
• Alc hdlp relay
• Body control module (bcm) (mounted on toe board in right footwell)
• C14
• C2 b6
• Data
• Door ajar indicator switch (closed w/door ajar)
• Door ajar sw
• Driver door latch
• Driver door module (ddm) (in lower center of driver's door)
• Driver seat belt switch (in driver's seat belt buckle assembly)
• Driver seat belt switch signal
• Exterior lights system
• G201 (at base of left "a" panel)
• G202 (at base of right "a" pillar)
• G205 (behind left seat at antenna module)
• Ground distribution system
• Hdlps on signal
• Hot at all times
• Hot in on & start
• I/p fuse block (in right front footwell, mounted to toe board)
• Ignition
• Ignition 1 voltage
• Ignition switch
• Inflatable restraint sensing & diagnostic module (sdm) (below center of dash, under hvac control head)
• Instrument panel cluster (ipc)
• Ipc fuse 19 10a
• Key in ign sw sig
• Key out ign sig
• Key out ign sw
• Left front door ajar switch signal
• Left turn
• Logic
• Nca
• Pnk
• Right turn
• S210 (in dash harness, 10 cm from breakout to blower motor control module)
• S301
• Seat belt indicator
• Splice pack sp201 (in dash harness)
• Splice pack sp202 (in dash harness)
• Star connector 1 (in dash harness, near left side of bcm)
• Tan
• Underhood fuse block (on right rear of engine compartment)
• W/o reclining bucket seat
• W/reclining bucket seat