WARNING SYSTEMS
Warning System Wiring Diagrams for Oldsmobile Alero GLS 2000
List of elements for Warning System Wiring Diagrams for Oldsmobile Alero GLS 2000:
- (4 door only)
- (below dash, left of steering column) data link connector (dlc)
- (olds level 2)
- (pont) (olds)
- 2.4l
- 3.4l
- A/c bfc fuse 10a
- A10
- A11
- A12
- A9 b1
- B10
- B11
- B12
- Bfc batt fuse 10a
- Body control module (bcm) (behind right side of dash)
- C12
- C3 b12
- C3 b9
- C3 c11
- Dome
- Engine coolant level switch (right side of eng compt)
- Fuse out
- G102 (left front shock tower)
- G202 (left side of dash)
- G300 (below left side of driver's seat)
- G301 (below right side of front passenger's seat)
- Ground
- Handle
- Head
- Hot at all times
- Hot in on or start
- Ign 1 pos voltage
- Ignition switch (key warning switch)
- Inadvertent power out
- Instrument cluster
- Int lps fuse 10a
- Interior lamps cntrl
- Interior lights system
- Key in ign in
- Left front door handle switch
- Left front door lock switch
- Left i/p junction block
- Left rear door jamb switch
- Lft frt door dome in
- Low eng coolant input
- Low oil press, hi temp, low fuel, brake, service eng, check oil, volts ind
- Low washer solvent in
- Micro- processor
- Nca
- Off
- Other door dome in
- Park
- Park brake in
- Park brake switch
- Park lamp in
- Parklamp fuse 15a
- Pnk
- Powertrain control module (pcm) (below left side of dash)
- Right front door handle switch
- Right front door lock switch
- Right i/p junction block
- Right rear door jamb switch
- Seat belt sw in
- Seat belt switch (part of driver's seat belt buckle)
- Second- ary latch
- Serial data
- Turn/ headlamp/ wiper switch assembly
- Underhood junction block
- Washer solvent level sensor (inside left front fender)