WIPER/WASHER
Wiper/Washer Wiring Diagram for Mitsubishi Lancer ES 2007
List of elements for Wiper/Washer Wiring Diagram for Mitsubishi Lancer ES 2007:
- (at right rear of trunk, on washer fluid reservoir)
- 2.0l
- 2.4l
- A/t
- A10x
- A11x
- Acc or on
- C116
- C138
- C210
- C214
- C226
- C228
- Circuit breaker
- Column ecu
- Column switch
- Dedicated fuse 22 10a
- Engine compartment relay box (left side of engine compartment)
- Engine controls system
- Etacs ecu
- Fast
- Front-ecu (in engine compartment relay box)
- G1 (at right front corner of engine compartment)
- G13 (at left front corner of engine compt)
- G14 (under front of center console)
- G3 (under right front kick panel)
- G6 (behind center of dash, near left center reinforcement)
- High
- Hot at all times
- Hot in
- Hot in on
- Hot in start
- Int
- Intermittent wiper interval adjusting knob
- Joint connector 1 (behind center of dash)
- Joint connector 2 (behind instrument cluster)
- Joint connector 3 (behind right side of dash)
- Joint connector 5 (behind instrument cluster)
- Junction block (behind left end of dash)
- Low
- M/t
- Mist
- Multi- purpose fuse 2 7.5a
- Multi- purpose fuse 5 7.5a
- Multi- purpose fuse 7 20a
- Off
- Or on
- Pnk
- Power tops system
- Powertrain control module (behind glove box)
- Slow
- Vehicle speed sensor (at left side of engine compartment)
- Wash
- Washer switch
- Windshield washer motor
- Windshield wiper motor (2.0l: on right rear of engine compt) (2.4l: at right rear of firewall)
- Wiper switch